Netgear M7300-24XF (XSM7224S) - ProSAFE 24-port, 10 Gigabit Stackable L2+ Managed Switch ユーザーズマニュアル
392
|
Chapter : Managing Device Security
ProSafe® XSM7224S 10G Managed Stackable Switch Software Administration Manual
Basic
From the Basic link, you can access the following pages:
802.1X Configuration
Use the 802.1X Configuration page to enable or disable port access control on the system.
To display the 802.1X Configuration page, click Security
Port Authentication
Basic
802.1X Configuration
.
To configure global 802.1X settings:
1.
Select the appropriate radio button in the Port Based Authentication State field to
enable or disable 802.1X administrative mode on the switch.
•
Enable
. Port-based authentication is permitted on the switch.
Note:
If 802.1X is enabled, authentication is performed by a RADIUS
server. This means the primary authentication method must be
RADIUS. To set the method, go to Security > Management
Security > Authentication List
RADIUS. To set the method, go to Security > Management
Security > Authentication List
and select RADIUS as method 1 for
defaultList. For more information, see <pdf>“Authentication List
Configuration” on page
Configuration” on page
•
Disable
- The switch does not check for 802.1X authentication before allowing traffic
on any ports, even if the ports are configured to allow only authenticated users.
Default value.
Default value.
2.
Use VLAN Assignment Mode to select one of options for VLAN Assignment mode: enable
and disable. The default value is disable.