Netgear M6100 – Campus Edge and SMB Core Chassis Switches ユーザーガイド

Peer Detection Status

Displays whether peer detection is enabled or 
disabled.

Use this page to configure the VPC interfaces on the device. A VPC interface is created by 
combining a port channel on the local device with a port channel on the peer device. The 
VPC interface on the local and peer devices share a common VPC identifier. You can 
configure multiple instances of VPC interfaces on each peer device in the VPC domain.



To display the Virtual Port Channel Interface Configuration page, click Switching > MLAG > 
Advanced > VPC Interface Configuration

. The following page is displayed.



Configure the VPC Interface.

From the LAG Interface list, select the ID of the local port channel to configure as a 

VPC interface.

Enter a VPC interface identifier value in the VPC Identifier field. The possible range is 1 to 

63. To form a VPC interface with a port channel on the peer device, the port channel on the 

peer device must use the same VPC identifier.

Click Add to add a new interface configuration.

Click Delete to delete a selected interface configuration.

Click Cancel to cancel the configuration on the screen and reset the data on the screen to 

the latest value of the switch.

Click Apply to send the updated configuration to the switch. Configuration changes take 

effect immediately.

The following table describes the non-configurable VPC Interface Configuration field.