Netgear M6100 – Campus Edge and SMB Core Chassis Switches ユーザーガイド

The CPU Utilization Threshold notification feature allows you to configure thresholds that, 
when crossed, trigger a notification. The notification is done via SNMP trap and SYSLOG 
messages.

To display the CPU Threshold page, click System > Management > System CPU Status > 
CPU Threshold

. A screen similar to the following is displayed.



Configure the Rising Threshold value. Notification is generated when the total CPU 

utilization exceeds this threshold value over the configured time period. The range is 1 

to 100.

Configure the Rising Interval value. This utilization monitoring time period can be 

configured from 5 to 86400 seconds in multiples of 5 seconds.

Configure the Falling Threshold. Notification is triggered when the total CPU utilization falls 

below this level for a configured period of time. The falling utilization threshold must be equal 

to or less than the rising threshold value. The falling utilization threshold notification is made 

only if a rising threshold notification was done previously. Configuring the falling utilization 

threshold and time period is optional. If the Falling CPU utilization parameters are not 

configured, then it takes the same value as Rising CPU utilization parameters. The range is 

1 to 100. 

Configure the Falling Interval. The utilization monitoring time period can be configured from 

5 seconds to 86400 seconds in multiples of 5 seconds.

Configure the CPU Free Memory Threshold value in KB.

Click Apply to send the updated configuration to the switch. Configuration changes take 

effect immediately.

Click Cancel to cancel the configuration on the screen and reset the data on the screen to 

the latest value of the switch.

Use this page to display the switch statistics.

To display the Switch Statistics page, click System > Management > Switch Statistics. A 
screen similar to the following is displayed.