Netgear M6100 – Campus Edge and SMB Core Chassis Switches ユーザーガイド

The Routing > OSPF folder contains links to the following web pages that you use to 
configure and display OSPF data:



To display the Basic OSPF Configuration page, click Routing > OSPF > Basic > OSPF 
Configuration

. The following page is displayed.



Configure the OSPF settings.

In the Admin Mode field, select the Enable or Disable option. If you select enable, 

OSPF will be activated for the switch. By default, OSPF is Enabled. You must configure 

a Router ID before OSPF can become operational. Use the IP Configuration page to 

configure a Router ID or issue the CLI command config router id. For more 

The Router ID is the 32-bit integer in dotted decimal format that uniquely identifies the router 

within the autonomous system (AS). If you want to change the Router ID, you must first 

disable OSPF. After you set the new Router ID, you must re-enable OSPF to have the 

change take effect. The default value is 0.0.0.0, although this is not a valid Router ID.

Click Apply to send the updated configuration to the switch. Configuration changes take 

effect immediately.

Click Cancel to cancel the configuration on the screen and reset the data on the screen to 

the latest value of the switch.

Match External Type 1

Sets External Type 1 OSPF Routes to be redistributed.

Match External Type 2

Sets External Type 2 OSPF Routes to be redistributed.

Match NSSA External Type 1

Sets NSSA External Type 1 OSPF Routes to be redistributed.

Match NSSA External Type 2

Sets NSSA External Type 2 OSPF Routes to be redistributed.