Netgear XCM8806 - 8800 SERIES 6-SLOT CHASSIS SWITCH ユーザーズマニュアル
Chapter 1. Getting Started
|
5
XCM8800 Web Management Interface User Guide
Setting Up the Web Management Interface
This section describes the setup process required to use the Web Management Interface
with the switch and includes the following topics:
with the switch and includes the following topics:
HTTP and HTTPS Setup
Before you can launch the Web Management Interface, you must enable the web server on
the switch. You can use either HTTP or HTTPS to access the Web Management Interface.
the switch. You can use either HTTP or HTTPS to access the Web Management Interface.
Note:
You must assign an IP address to a VLAN for management access to
the switch.
Web Access Using HTTP
To enable HTTP web access, enter the following command:
XCM8806.1 # enable web http
The switch is now ready for web access using HTTP at the URL http://<switch_ip>.
Web Access Using HTTPS
To enable HTTPS Web access, first check to see if the SSL module is installed. Enter the
following command:
following command:
XCM8806.1 # show ssl
If the following displays, the SSL module is not installed:
SSL Module: Not Installed
XCM8806.2 #
The SSL module has to be installed to enable HTTPS Web access. (See the NETGEAR
8800 Series Chassis Switch User Manual “Secure Socket Layer” in the Security chapter and
“Guidelines for Activating SSL” in the Software Upgrade and Boot Options appendix.)
8800 Series Chassis Switch User Manual “Secure Socket Layer” in the Security chapter and
“Guidelines for Activating SSL” in the Software Upgrade and Boot Options appendix.)
After the SSL module is installed, create a certificate by entering the following command:
XCM8806.2 # configure ssl certificate privkeylen 1024 country us
organization netgear common-name name1
To enable HTTPS Web access, enter the following command:
8806.1 # enable web https
The switch is now ready for Web access using HTTPS at the URL https://<switch_ip>.