Netgear FS526Tv2 - 24-Port Smart Switch with Gigabit Ports ユーザーガイド

Bind all ports or LAGs to the IP ACL. In the orange bar, click the square next to 
PORT or LAG. All ports or LAGs are bound to the MAC ACL.

(Clicking a second time removes all ports or LAGs from the binding.)

Click the Apply button.

The settings are saved, and the ACL information is added to both the Interface Binding 
Status table and the IP Binding Table on the IP Binding Table screen (see 

For information about how to change the rule or remove the rule, see the procedures at the 
end of 

A MAC ACL consists of a set of rules that are matched sequentially against a packet. With a 

MAC ACL, you specify the MAC address of the source device, destination device, or both. 
When a packet meets the match criteria of a rule, the specified rule action (permit or deny) is 
applied, and any additional rules are not checked for a match for that packet.

These are the basic steps to configure a MAC ACL:

Create a MAC-based ACL name (see 

197).

Create a rule and assign it to the ACL (see 

Assign the ACL to an interface (see 

You can view the MAC ACL configuration on the MAC Binding Table (see 

206).

You need to create a MAC ACL name before you can add any rules to the MAC ACL and 
assign the MAC ACL to a port or LAG.



Select Security > ACL > Basic > MAC ACL Configuration.