Netgear FS526Tv2 - 24-Port Smart Switch with Gigabit Ports ユーザーガイド

Configure the settings as described in the following table.

File Type

From the File Type menu, select Code.

Image Name

From the Image Name menu, select the image to which you want to download the 
new firmware file: Image 1 or Image 2.

The new firmware file overwrites any old firmware file that is stored in the selected 
image location.

Server Address Type The selection of the Server Address Type menu is fixed at IPv4. the TFTP server 

must be a server with an IPv4 address.

TFTP Server IP

The IP address of the TFTP server.

Transfer File Path

The path on the TFTP server where the file is located. You can enter up to 
32

 

characters. Include the backslash at the end of the path. Do not enter a path 

name with a space. Leave this field blank to save the file to the root TFTP directory.

Remote File Name

The name of the file that you want to download from the TFTP server. You can enter 
up to 32 characters. Do not enter a file name with a space.

Select the Start File Transfer check box.

Confirm your selection.

Click the Apply button.

The file downloads to the smart switch. After the file has successfully downloaded to the 
smart switch, the following message displays: File transfer operation completed 
successfully.

You are now ready to upgrade the firmware on the smart switch. For more information, see 

After you have downloaded the firmware to the smart switch over HTTP or TFTP, you need to 

select the active image (Image 1 or Image 2), and reboot the smart switch.

In some cases, such as a major firmware upgrade, you might need to erase the configuration 
and manually reconfigure the smart switch after the firmware upgrade. However, this 
situation is unusual. NETGEAR recommends that you read the firmware release notes 
before you upgrade the firmware.



Select Maintenance > File Management > Dual Image > Dual Image Configuration.