Netgear XCM8806 - 8800 SERIES 6-SLOT CHASSIS SWITCH ユーザーズマニュアル
116
|
Chapter 5. Configuring Slots and Ports on a Switch
NETGEAR 8800 User Manual
On the NETGEAR 8806 switch, the XCM88S1 with XCM888F installed has eight 1 Gbps fiber
SFP-GBIC data ports
SFP-GBIC data ports
Configuring Ports on a Switch
Note:
A port can belong to multiple virtual routers (VRs). For more
information on VRs, see
.
This section describes the following topics of configuring ports on a switch:
Port Numbering
XCM8800 runs on both stand-alone and modular switches, and the port numbering scheme
is slightly different on each.
is slightly different on each.
On a NETGEAR 8800 switch, the port number is a combination of the slot number and the
port number. The nomenclature for the port number is as follows:
port number. The nomenclature for the port number is as follows:
slot:port
For example, if an I/O module that has a total of four ports is installed in slot 2 of the chassis,
the following ports are valid:
the following ports are valid:
•
2:1
•
2:2
•
2:3
•
2:4
You can also use wildcard combinations (*) to specify multiple modular slot and port
combinations. The following wildcard combinations are allowed:
combinations. The following wildcard combinations are allowed:
•
slot:*
—Specifies all ports on a particular I/O module or stack node
•
slot:x-slot:y
—Specifies a contiguous series of ports on multiple I/O modules or stack
nodes
•
slot:x-y
—Specifies a contiguous series of ports on a particular I/O module or stack node
•
slota:x-slotb:y
—Specifies a contiguous series of ports that begin on one I/O module or
stack node and end on another I/O module or stack node