Netgear XCM8806 - 8800 SERIES 6-SLOT CHASSIS SWITCH ユーザーズマニュアル
Chapter 5. Configuring Slots and Ports on a Switch
|
137
NETGEAR 8800 User Manual
enable loopback-mode v1
configure v1 add port 5
configure sharing health-check member-port 5 add track-tcp 192.168.1.101
tcp-port 8080
configure sharing health-check member-port 6 add track-tcp 192.168.1.102
tcp-port 8080
configure sharing health-check member-port 7 add track-tcp 192.168.1.103
tcp-port 8080
configure sharing health-check member-port 8 add track-tcp 192.168.1.104
tcp-port 8080
Displaying Switch Load Sharing
You can display static and dynamic load sharing. In the link aggregation displays, the types
are shown by the following aggregation controls:
are shown by the following aggregation controls:
•
Static link aggregation—static
•
Link Aggregation Control Protocol—LACP
•
Health check link aggregation—hlth-chk
To verify your configuration, use the following command:
show ports sharing
To verify LACP configuration, use the following command:
show lacp
To display information for the specified LAG, use the following command:
show lacp lag <group-id> {detail}
To display LACP information for a specific port that is a member of a LAG, use the following
command:
command:
show lacp member-port <port> {detail}
on page 148 for information on displaying summary
load-sharing information.
To clear the counters, use the following command:
clear lacp counters
You can display the LCAP counters for all member ports in the system. To display the LACP
counters, use the following command:
counters, use the following command:
show lacp counters
To display information for a health check LAG, use the following command:
show sharing health-check