Netgear XCM8806 - 8800 SERIES 6-SLOT CHASSIS SWITCH ユーザーズマニュアル

To configure the switch for the Smart Redundancy feature, use the following command:

enable smartredundancy <port_list>

To disable the Smart Redundancy feature, use the following command:

disable smartredundancy <port_list>

Verifying Software-Controlled Redundant Port Configurations

You can verify the software-controlled redundant port configuration by issuing a variety of CLI 
commands.

To display the redundant ports as well as which are active or members of load-sharing 
groups, use the following command:

show ports redundant

To display information on which ports are primary and redundant software-controlled 
redundancy ports, use the following command:

show ports {mgmt | <port_list>} information {detail}

See 

 for more information on the 

show ports information

 

command.

Displaying Port Information

You display summary port configuration information using the 

show ports {mgmt | 

<port_list>} configuration {no-refresh}

 and 

show ports {mgmt | <port_list>} 

information {detail}

 

commands.

The 

show ports configuration

 

command shows you either summary configuration 

information on all the ports, or more detailed configuration information on specific ports. If you 
specify the 

no-refresh

 parameter, the system displays a snapshot of the data at the time you 

issue the command.

The 

show ports information

 

command shows you either summary information on all the 

ports, or more detailed information on specific ports. The output from the command differs 
very slightly depending on the platform you are using.

You can display real-time port utilization information, by issuing the following command:

show ports {mgmt | <port_list> | stack-ports <stacking-port-list>} utilization 

{bandwidth | bytes | packets}

When you use a parameter (packets, byte, or bandwidth) with the above command, the 
display for the specified type shows a snapshot per port when you issued the command.

Digital Diagnostic Monitoring Interface (DDMI) provides critical information about the installed 
optic module and is supported on all NETGEAR 8800 blades that use 10G XFP optic 
modules. To display basic or detailed system information about XFP optic modules, use the 
following commands: