Netgear XCM8806 - 8800 SERIES 6-SLOT CHASSIS SWITCH ユーザーズマニュアル

Configures the sampling rate on an edge port.

Enables sFlow on the edge port.

Enables sFlow globally on the switch.

configure sflow collector 55.55.55.69 vr vr-mgmt

configure sflow ports 4:12 sample-rate 1024

enable sflow ports 4:12

enable sflow

Displaying sFlow Information

To display the current configuration of sFlow, use the following command:

show sflow {configuration}

To display the sFlow statistics, use the following command:

show sflow statistics

Using RMON

Using the Remote Monitoring (RMON) capabilities of the switch allows network 
administrators to improve system efficiency and reduce the load on the network. 

This section describes the following topics:

•     About RMON 

•     Supported RMON Groups of the Switch 

•     Configuring RMON 

•     Event Actions 

•     Displaying RMON Information 

You can use the RMON features of the system only if you have an 

RMON management application and have enabled RMON on the 
switch. 

About RMON 

RMON is the common abbreviation for the Remote Monitoring Management Information 
Base (MIB) system defined by the Internet Engineering Task Force (IETF) documents RFC 
1757 and RFC 2021, which allows you to monitor LANs remotely. 

A typical RMON setup consists of the following two components: 

RMON agent