Netgear XCM8806 - 8800 SERIES 6-SLOT CHASSIS SWITCH ユーザーズマニュアル
Chapter 11. Virtual Routers
|
287
NETGEAR 8800 User Manual
One instance of each routing protocol is spawned for VR-Default during the XCM8800
system boot-up, and these routing instances cannot be deleted.
system boot-up, and these routing instances cannot be deleted.
User Virtual Routers
Note:
User VRs are supported only on the platforms listed for this feature
on page 798. When a modular switch contains modules
or switches that do not support user VRs, the ports on those devices
cannot be added to a user VR.
cannot be added to a user VR.
User VRs are the VRs created by users in addition to the system VRs. When a new user VR
is created, by default, no ports are assigned, no VLAN interface is created, and no support for
any routing protocols is added.
is created, by default, no ports are assigned, no VLAN interface is created, and no support for
any routing protocols is added.
User Virtual Router Configuration Domain
When you create user VRs, you must configure each VR separately, configuring routing
protocols and VLANs for each one. To simplify the configuration process, the XCM8800
software supports a VR configuration domain or context. When you enter a VR command, it
is applied to the currently selected VR context, and you can use VR commands to change
context to a different VR. The VR commands include all the BGP, OSPF, PIM, and RIP
commands, and the commands listed in
protocols and VLANs for each one. To simplify the configuration process, the XCM8800
software supports a VR configuration domain or context. When you enter a VR command, it
is applied to the currently selected VR context, and you can use VR commands to change
context to a different VR. The VR commands include all the BGP, OSPF, PIM, and RIP
commands, and the commands listed in
Table 30. Virtual Router Commands
[enable | disable] ipforwarding
clear iparp
a
clear counters iparp
a
configure iparp
a
configure iparp [add | delete]
a
[enable | disable] iparp
a
show iparp
a
configure iproute [add | delete]
a
show iproute
a
show ipstats
a
rtlookup
create vlan <vlan-name>
[enable | disable] igmp