Netgear XCM8806 - 8800 SERIES 6-SLOT CHASSIS SWITCH ユーザーズマニュアル

configure mvr add vlan mvlan

create stpd stp1

configure stp1 add vlan v1 port all

enable stpd stp1 port all

configure mvr vlan v1 add receiver port 1:3,1:4

enable mvr

Displaying Multicast Information

The following sections describe how to display multicast information:

Displaying the Multicast Routing Table

To display part or all of the entries in the multicast routing table, use the following command:

show iproute {ipv4} {{vlan} <name> | [<ipaddress> <netmask> | <ipNetmask>] | 

origin [direct | static | mbgp | imbgp | embgp]} multicast {vr <vr_name>}

Displaying the Multicast Cache

The multicast cache stores information about multicast groups. To display part or all of the 
entries in the multicast cache, use the following command:

show mcast cache {{vlan} <name>} {{[group <grpaddressMask> | <grpaddressMask>] 

{source <sourceIP> | <sourceIP>}} {type [snooping | pim | mvr]} {with-in-port} | 

{summary}}

Looking Up a Multicast Route

To look up the multicast route to a specific destination, use the following command with the 

multicast

 option:

rtlookup [<ipaddress> | <ipv6address>] { unicast | multicast | rpf } 

{ vr <vr_name> }

Looking Up the RPF for a Multicast Source

To look up the RPF for a multicast source, use the following command with the 

rpf

 option: