Netgear GSM7224v2 - 24-Port Layer 2 Managed Gigabit Switch ユーザーズマニュアル
Chapter 4. Routing
|
255
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
Advanced
.From the Advanced link, you can access the following pages:
Static ARP Cache
To display the Static ARP Cache page, click Routing
ARP
Advanced
ARP Create.
ARP Static Configuration
Use this screen to add an entry to the Address Resolution Protocol table.
1.
Use IP Address to enter the IP address you want to add. It must be the IP address of a
device on a subnet attached to one of the switch's existing routing interfaces.
device on a subnet attached to one of the switch's existing routing interfaces.
2.
Use MAC Address to specify the unicast MAC address of the device. Enter the address as
six two-digit hexadecimal numbers separated by colons, for example 00:06:29:32:81:40.
six two-digit hexadecimal numbers separated by colons, for example 00:06:29:32:81:40.
3.
Click ADD to add a new static ARP entry to the switch.
4.
Click DELETE to delete an existing static ARP entry from the switch.
5.
Click APPLY to change the MAC Address mapping to the IP. Configuration changes take
effect immediately.
effect immediately.