Netgear WGX102v2 - 54 Mbps Wall-Plugged Wireless Range Extender 参照マニュアル
Reference Manual for the 54 Mbps Wall-Plugged Wireless Range Extender WGX102
Installing the Wireless Range Extender
3-5
202-10042-02 v1.1
Plug the WGX102 into an electrical outlet near the wireless computer that you want to connect,
and wait one minute. All three LEDs on the WGX102 light up.
and wait one minute. All three LEDs on the WGX102 light up.
•
Power: The power light should turn solid green. If it does not, see
•
HomePlug/Internet: The Internet port light should be lit. If not, make sure the Ethernet cable
on the XE102 you connected in the previous step is securely attached to the XE102 and the
router, that the router is connected to the modem, and the modem is powered on.
on the XE102 you connected in the previous step is securely attached to the XE102 and the
router, that the router is connected to the modem, and the modem is powered on.
•
Wireless: The Wireless light should be lit. If the Wireless light is not lit, see
This completes the powerline installation. You may connect additional XE102 bridges to your
network.
network.
Now, Add the WGX102 to Your Wireless Network
Figure 3-6: Powerline and wireless network interconnections
There are two scenarios for adding the WGX102 to your wireless network:
Wireless
XE102
Internet
Access
Access
WGX102
Computer
Wireless
Wireless Network
Note: The WGX102 must be configured with the same
wireless and IP address settings as your existing network.
wireless and IP address settings as your existing network.
Router
Wireless Network