Netgear WGX102v2 - 54 Mbps Wall-Plugged Wireless Range Extender 参照マニュアル

3-6

Installing the Wireless Range Extender

•

Plug and play installation: This option works when the wireless settings of your existing 
network are the same as the default WGX102. 

•

Custom installation: Use this option when the wireless settings or IP address settings of your 
existing network are different from the default WGX102. Refer to 

These procedures for using these two options are presented below.

If your network uses a NETGEAR wireless router with its default Wireless Network Name 
(NETGEAR) and you do not use security settings, then the WGX102 works immediately, and the 
installation is complete. If this is not the case, go to the following section, Custom WGX102 
Setup. 

You can connect additional XE102 bridges to your network. If you want to change the default 
powerline passwords for increased security on your powerline network, see 

. For information about setting up wireless security see 

, and the documentation for your wireless 

router.