Netgear EX7300 – Nighthawk X4 WiFi Range Extender ユーザーズマニュアル

ページ / 48
Get Started 
10
Nighthawk X4 AC2200 WiFi Range Extender 
Use the Extender in Extender Mode
The extender repeats signals from an existing WiFi router or access point. Place the 
extender, apply power, and connect the extender to your WiFi network.
Note:
You can also use the extender as a WiFi access point and create a 
new WiFi hotspot by using a wired Ethernet connection. See 
15.
Place the Extender and Apply Power
To place the extender and apply power:
1. 
Set the Access Point/Extender switch 
 to the Extender position.
2. 
Place your extender in the same room as your WiFi router.
Proximity to the WiFi router is required only during the initial setup process.
3. 
Plug the extender into an electrical outlet.
4. 
Wait for the Power LED 
 to light green. 
If the Power LED does not light, press the Power On/Off button on the extender.
Connect to an Existing WiFi Network
To extend the range of your WiFi network, you must connect the extender to your existing 
WiFi network. You can do this in one of two ways:
Connect with WPS. For more information, see 
10.
Connect with web browser setup. For more information, see 
Connect With WPS
Wi-Fi Protected Setup (WPS) lets you join a secure WiFi network without typing the network 
name and password.
Note:
WPS does not support WEP network security. If you are using WEP 
security, follow the instructions in 
12.