KitchenAid 36" Convertible Island-Mount 400-CFM Glass Canopy Hood インストールガイド

RANGE HOOD CARE

Cleaning

IMPORTANT: Clean the hood and grease filters frequently 

according to the following instructions. Replace grease 

filters before operating hood.

To avoid damage to the exterior surface, do not use steel wool 

or soap-filled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:

 

■

Liquid detergent soap and water, or all-purpose cleanser

 

■

Wipe with damp soft cloth or nonabrasive sponge, 

and then rinse with clean water and wipe dry.

1.  Remove the filter by pulling the spring release handle 

and then pulling down the filter.

2.  Wash metal filter as needed in dishwasher or hot 

detergent solution.

3.  Reinstall the filter by making sure the spring release handles 

are toward the front. Insert aluminum filter into upper track.

4.  Push in spring release handle.
5.  Push up on metal filter and release handle to latch into place.

The charcoal filter is not washable. It should last up to 

6 months with normal use. Replace with Charcoal Filter 

Kit Number W10412939.
To replace charcoal filter:
1.  Remove metal grease filter from range hood. 

See “Metal Grease Filter” in this section.

2.  Bend spring clips away from metal grease filter.

3.  Place charcoal filter into top side of metal filter.

4.  Bend spring clips back into place to secure the 

charcoal filter to the metal filter.

5.  Replace metal grease filter. See “Metal Grease Filter” 

in this section.

Turn off the range hood and allow the halogen lamp to cool. 

To avoid damage or decreasing the life of the new bulb, 

do not touch bulb with bare fingers. Replace bulb, using 

tissue or wearing cotton gloves to handle bulb.
If new lights do not operate, make sure the lamps 

are inserted correctly before calling service.
1.  Disconnect power.
2.  Use a flat-blade screwdriver and gently pry 

the light cover loose.

3.  Remove the lamp and replace with a 120-volt, 40-watt 

maximum, halogen lamp made for a G-9 base.

4.  Replace the light cover.
5.  Reconnect power.