KitchenAid 36" Convertible Island-Mount 400-CFM Glass Canopy Hood インストールガイド

 * Vented installations only
 ** Non-vented (recirculating) installations only

Minimum distance “C”: 24" (61 cm) from electric cooking 

surface, 27" (68.6 cm) from gas cooking surface
Suggested maximum distance “C”: 36" (91.4 cm)

The chimneys can be adjusted for different ceiling heights. 

See the following chart.

Min. ceiling height

Max. ceiling height

Electric cooking 

surface

7' 8" (2.34 m)

9' 10" (3 m)

Gas cooking 

surface

7' 11" (2.41 m)

9' 10" (3 m)

Min. ceiling height

Max. ceiling height

Electric cooking 

surface

7' 8" (2.34 m)

10' 3" (3.12 m)

Gas cooking 

surface

7' 11" (2.41 m)

10' 3" (3.12 m)

NOTE: The range hood chimneys are adjustable and designed 

to meet varying ceiling or soffit heights depending on the 

distance “C” between the bottom of the range hood and the 

cooking surface. For higher ceilings, a Stainless Steel Chimney 

Extension Kit Part Number W10688278 is available from your 

dealer or an authorized parts distributor. The chimney extension 

replaces the upper chimney shipped with the range hood.

Venting Requirements

(vented models only)

 

■

Vent system must terminate to the outdoors except  

for non-vented (recirculating) installations.

 

■

Do not terminate the vent system in an attic or other 

enclosed area.

 

■

Do not use 4" (10.2 cm) laundry-type wall cap.

 

■

Use metal vent only. Rigid metal vent is recommended. 

Plastic or metal foil vent is not recommended.

 

■

The vent system must have a damper. If the roof 

or wall cap has a damper, do not use the damper 

supplied with the range hood.

 

■

Use a straight run or as few elbows as possible.

 

■

Use no more than three 90° elbows.

 

■

Make sure there is a minimum of 24" (61 cm) of straight 

vent between the elbows if more than 1 elbow is used.

 

■

Do not install 2 elbows together.

 

■

Use vent clamps to seal all joints in the vent system.

 

■

Use caulking to seal exterior wall or roof opening 

around the cap.

 

■

The size of the vent should be uniform.

An additional back draft damper should be installed to minimize 

backward cold air flow and a thermal break should be installed 

to minimize conduction of outside temperatures as part of the 

vent system. The damper should be on the cold air side of the 

thermal break.
The break should be as close as possible to where the vent 

system enters the heated portion of the house.