KitchenAid 36" Convertible Island-Mount 400-CFM Glass Canopy Hood インストールガイド

Assemble Range Hood

1.  Install transition on top of hood (if removed for shipping) 

with 2 - 3.5 x 9.5 mm sheet metal screws.

2.  Position the 4 vertical supports (A) with the notches 

at the bottom and attach to the range hood using 

16 - 4.2 x 8  mm screws.

3.  Attach the horizontal support (B) using 8 - 

4.2 x 8 mm screws.

4.  Attach a second set of vertical supports (A) and set 

the vertical height (B). See “Installation Dimensions” 

in the “Location Requirements” section to help 

determine the desired dimension for vertical height “B.”
Secure with 16 - 4.2 x 8 mm T20

®

 screws.

Install Range Hood

1.  Attach the air deflector to the upper horizontal support 

using 2 mounting screws.

2.  Measure the length of 6" (15.2 cm) duct needed 

to connect the transition to the deflector.
NOTE: Vent should fit up inside the deflector 

1" (2.5 cm) minimum.

3.  Install vent between the transition and the deflector.

NOTE: To make vent installation easier, temporarily remove 

the deflector from the chimney support bracket and replace 

after vent section is in place.

4.  Seal all connections with vent clamps. Continue 

with “Range Hood Installation” in this section.

1.  Using 2 or more people, lift the range hood assembly 

and attach it by snapping the vertical supports to the 

spring clips in the upper horizontal support bracket 

that is mounted to the ceiling.
NOTE: The range hood assembly must be held in place 

while you are installing the screws in the next step.

2.  Install 16 - 4.2 x 8 mm screws and tighten to secure.

1.  Install vent system.
2.  Push duct over the exhaust outlet. Seal all connections 

with vent clamps.

3.  Use caulk to seal all openings.