Xerox 2101 ST Digital Copier/Printer インストールガイド

The Fiery EX2101 searches the network for AppleTalk zones in your network segment. 
Scroll through the list to select the AppleTalk zone in which you want the 
Fiery EX2101 to appear. If your segment has only one zone, the Fiery EX2101 is 
assigned to that zone automatically.

The message “No AppleTalk zone found” may mean your network has no zones, or the 
network cable is not connected (see 

). Choose OK to dismiss the message.

When you set an IP address, subnet mask, or gateway address for the Fiery EX2101 
during Setup, you can allow the Fiery EX2101 to get these addresses automatically 
from a DHCP or BOOTP server. Turn on or restart the Fiery EX2101 and allow it to 
reach Idle. Make sure the DHCP or BOOTP server is running, and then perform 
Fiery EX2101 Setup.

To configure the Fiery EX2101, choose each protocol and enter the settings for that 
protocol. You can enable AppleTalk, TCP/IP, and IPX/SPX communication 
simultaneously.

Network Setup

Protocol Setup

Select Yes if you have an AppleTalk network connected to the Fiery EX2101. This 
setting enables the Fiery EX2101 to communicate over AppleTalk networks.

To configure the Fiery EX2101 for TCP/IP, choose TCP/IP Setup.

Choose Ethernet Setup and enter the appropriate settings. Choose each network 
type you use (Ethernet) and enter the appropriate settings.