Xerox WorkCentre 3335/3345 ユーザーガイド
The equipment may not be capable of correct operation at the higher data speeds
designated. 33.6kbps and 56kbps connections are likely to be restricted to lower bit
rates when connected to some PSTN implementations. Telecom will accept no
responsibility for difficulties that arise in such circumstances.
designated. 33.6kbps and 56kbps connections are likely to be restricted to lower bit
rates when connected to some PSTN implementations. Telecom will accept no
responsibility for difficulties that arise in such circumstances.
2.
Immediately disconnect this equipment should it become physically damaged, then
arrange for its disposal or repair.
arrange for its disposal or repair.
3.
This modem shall not be used in any manner which could constitute a nuisance to
other Telecom customers.
other Telecom customers.
4.
This device is equipped with pulse dialing, while the Telecom standard is DTMF tone
dialing. There is no guarantee that Telecom lines will always continue to support
pulse dialing.
dialing. There is no guarantee that Telecom lines will always continue to support
pulse dialing.
5.
Use of pulse dialing, when this equipment is connected to the same line as other
equipment, may give rise to 'bell tinkle' or noise and cause a false answer condition.
If you encounter such problems, do not contact the Telecom Faults Service.
equipment, may give rise to 'bell tinkle' or noise and cause a false answer condition.
If you encounter such problems, do not contact the Telecom Faults Service.
6.
DTMF tones dialing is the preferred method because it is faster than pulse (decadic)
dialing and is readily available on almost all New Zealand telephone exchanges.
dialing and is readily available on almost all New Zealand telephone exchanges.
Warning
No '111' or other calls can be made from this device during a mains power failure.
7.
This equipment may not provide for the effective hand-over of a call to another
device connected to the same line.
device connected to the same line.
8.
Some parameters required for compliance with Telecom Telepermit requirements
are dependent on the equipment (computer) associated with this device. The
associated equipment shall be set to operate within the following limits for
compliance with Telecom Specifications:
are dependent on the equipment (computer) associated with this device. The
associated equipment shall be set to operate within the following limits for
compliance with Telecom Specifications:
For repeat calls to the same number:
• There shall be no more than 10 call attempts to the same number within any 30
minute period for any single manual call initiation, and
• For automatic calls to different numbers:
• The equipment shall be set to ensure that automatic calls to different numbers
• The equipment shall be set to ensure that automatic calls to different numbers
are spaced such that there is no less than five seconds between the end of one
call attempt and the beginning of another.
call attempt and the beginning of another.
9.
For correct operation, total of the RNs of all devices connected to a single line at
any time should not exceed five.
any time should not exceed five.
Material Safety Data Sheets
For Material Safety Data information regarding your printer, go to:
• North America:
-
WorkCentre
®
3335:
-
WorkCentre
®
3345:
• European Union:
B-11
Xerox
®
WorkCentre
®
3335/3345 Multifunction Printer
User Guide
Regulatory Information