Xerox DocuTech 6100 Production Publisher ユーザーガイド

 
DT6180 HandyBook                                                                                                                   55 

First group of problems don’t have case number

Look-up Solutions, listed in alphabetical order immediately following this table. 
Area 
P=Processor 
I=Interposer 
F=Finisher 

  Paper path jams, misfeeds, 

•  Check the area where the jams are 

occurring to ensure that the paper 
path is clear of paper and other 
obstructions. 

•  If a jammed sheet of paper tears 

when being removed, ensure that you 
have removed all of the sheet pieces. 

•  Ensure that the paper path baffles are 

in the correct seated position. 

•  Ensure that the stock is loaded 

properly in the trays, with the rear and 
side guides against the stack. 

•  Check the sheets in the bottom of the 

paper tray for damage. If they are 
damaged, discard the sheets. 

•  Ensure that the stock is not loaded 

above the bottom of the red line in the 
paper tray. 

•  Ensure that the stock has no bent 

corners, or tears, and that the edges 
are straight.  

•  Remove any damaged sheets. 

•  Repeated jamming may be due to a 

paper curl problem that can be 
resolved by adjusting the decurler 
lever. Refer to the procedure, 
"Adjusting for paper curl," in this 
guide. 

•  Paper weight less than substance 20 

(75 g/m2) will require careful setting 

•  of the decurler. Refer to the 

procedure, "Adjusting for paper curl," 
in this guide. 

•  If the misfeeds are occurring in the 

paper tray, ensure that the paper 
feeder is latched by pressing down on 

N