Xerox DocuTech 180 HighLight Color System ユーザーガイド
DocuTech 128/155/180 HighLight Color Operator Guide
3- 9
Routine maintenance
Table 3-2. Tray length settings for custom transfer assist
blades (U.S. markets)
blades (U.S. markets)
Table 3-3. Try length settings fro custom transfer assist
blades (Non-U.S. markets)
blades (Non-U.S. markets)
Adjusting for paper curl
Each sheet of paper has a natural curve called the curl. Storing or
using the paper under humid conditions may increase the curl.
When too much curl causes paper handling problems, adjust the
decurler in the processor. The decurler flattens the paper after
fusing.
using the paper under humid conditions may increase the curl.
When too much curl causes paper handling problems, adjust the
decurler in the processor. The decurler flattens the paper after
fusing.
Measuring the paper curl
1. Program and print five 1-sided, 8.5 x 11 inch (216 x 279 mm)
sheets to the top tray.
NOTE: Keep the image toward you, as shown in Figure 3-5.
NOTE: Keep the image toward you, as shown in Figure 3-5.
2. Measure the amount of curl in the prints by holding the five
prints in the top center of the short edge.
Paper Size
Set Paper Size
11.5 to 11.7 inches/292 to 297 mm
11.7 inches/297 mm
12.1 to 12.9 inches/307 to 328 mm
13 inches/330 mm
13 to 13.9 inches/330 to 353 mm
14 inches/356 mm
Paper Size
Set Paper Size
10 to 10.9 inches/254 to 277 mm
11 inches/279 mm
11.5 to 11.6 inches/292 to 294 mm
11.7 inches/3297 mm
12.1 to 12.9 inches/307 to 328 mm
13 inches/330 mm