Zanussi ZRG15807WA ユーザーズマニュアル

Water flows on the floor.

The melting water outlet is not

connected to the evaporative

tray above the compressor.

Attach the melting water outlet to

the evaporative tray.

Door is misaligned or interferes

with ventilation grill.

The appliance is not levelled.

Refer to "Levelling".

The temperature in the appliance

is too low/too high.

The temperature regulator is

not set correctly.

Set a higher/lower temperature.

The door is not closed correct-

ly.

Refer to "Closing the door".

The food products' tempera-

ture is too high.

Let the food products temperature

decrease to room temperature be-

fore storage.

Many food products are stored

at the same time.

Store less food products at the

same time.

The thickness of the frost is

greater than 4-5 mm.

Defrost the appliance.

The door has been opened of-

ten.

Open the door only if necessary.

If the advice does not lead to the

desired result, contact the nearest

Authorised Service Centre.

Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.

2. Remove the lamp cover (refer to the

illustration).

3. Replace the used lamp with a new lamp of

the same power and specifically designed

for household appliances (the maximum

power is shown on the lamp cover).

4. Install the lamp cover.

5. Tighten the screw to the lamp cover.

6. Connect the plug to the mains socket.

7. Open the door.

Make sure that the light comes on.

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective door

gaskets. Contact the Authorised Service

Centre.

Refer to Safety chapters.

This appliance can be installed in a dry, well

ventilated indoor where the ambient