Timberk SWH FSM1 50 V ユーザーズマニュアル
www.timberk.com • electrical storage water heater
3
1. Completely automatic control: automatic water heating, continuous auto-
matic water temperature control.
2. DROP Defense – leakage protection and protection against surplus pres-
2. DROP Defense – leakage protection and protection against surplus pres-
sure within a tank (pressure safety valve).
HOT Defense – two-stage overheating protection (thermostat and tempera-
HOT Defense – two-stage overheating protection (thermostat and tempera-
ture limiter).
ALL PROTECTION SYSTEMS ARE RELIABLE AND SAFE.
3. Pipes of heating elements are designed taking into account high heat load:
ALL PROTECTION SYSTEMS ARE RELIABLE AND SAFE.
3. Pipes of heating elements are designed taking into account high heat load:
safe and reliable, with an increased service life.
4. NON CFC urethane foam insulation of increased thickness: excellent heat
4. NON CFC urethane foam insulation of increased thickness: excellent heat
A number of precautions is to be observed upon operation of the fan heat-
er. Improper operation as a result of ignoring precautions may harm health
of the user and other people, as well as damage their property.
1. Any electrical appliance must be supervised when in operation, espe-
1. Any electrical appliance must be supervised when in operation, espe-
cially if there are children nearby. Make sure children do not touch the ap-
pliance.
2. Prior to installing the water heater, not connecting it to electrical main,
2. Prior to installing the water heater, not connecting it to electrical main,
check and make sure the outlet for the water heater has a ground pin and
if it is properly earthed. If there is no earth circuit in your electrical main then
operation of the water heater is dangerous for your life.
3. Connect the water heater only to 220-230V, 50Hz main. If necessary,
3. Connect the water heater only to 220-230V, 50Hz main. If necessary,
find out parameters of your mains at power suppliers.
4. To prevent overheating and risk of fire, as well as damage of internal
4. To prevent overheating and risk of fire, as well as damage of internal
electrical main, do no modify the power cord’s length and do no connect
the water heater through electrical extenders.
5. It is forbidden to switch on the water heater if it is not filled with water or
5. It is forbidden to switch on the water heater if it is not filled with water or
if water cannot go through a pressure safety valve.
6. Never use the water heater if it is broken.
7. Do not remove the water heater cover when it is in operation.
8. Immediately unplug the water heater from electrical main if strange
6. Never use the water heater if it is broken.
7. Do not remove the water heater cover when it is in operation.
8. Immediately unplug the water heater from electrical main if strange
sounds, odor or smoke are coming from it.
9. Always unplug the water heater from electrical main during a thunder-
9. Always unplug the water heater from electrical main during a thunder-
storm.
10. Prior to cleaning and maintenance of the water heater unplug it from
10. Prior to cleaning and maintenance of the water heater unplug it from
electrical main. Cleaning and maintenance must be performed in compli-
ance with instructions of this operation manual.
11. Do not use hazardous chemical substances to clean the water heater
11. Do not use hazardous chemical substances to clean the water heater
and prevent their contact with the appliance.
12. To prevent electrical shock the damaged power cord must be replaced
12. To prevent electrical shock the damaged power cord must be replaced
only in manufacturer’s authorized service centers by qualified specialists.
13. To prevent electrical shock do not place the power cord nearby heating
13. To prevent electrical shock do not place the power cord nearby heating
devices and flammables or combustibles.
14. Do not press buttons on the control panel of the water heater and its
14. Do not press buttons on the control panel of the water heater and its
remote controller (for some models) otherwise but by your fingers.
15. Since temperature of water in the water heater can reach +75°C, when
15. Since temperature of water in the water heater can reach +75°C, when
it is in operation you should not place your body parts under hot water at
2. PRECAUTIONS
the first run.
To prevent burns you should adjust the temperature of the discharging
To prevent burns you should adjust the temperature of the discharging
water.
16. Do not use the water heater for purposes not specified by this oper-
16. Do not use the water heater for purposes not specified by this oper-
ation manual.
17. Do not use the water heater in an explosive or corrosive environment.
17. Do not use the water heater in an explosive or corrosive environment.
Do not store gas and other volatile flammable liquids next to the appliance
– it is very dangerous!
18. It is forbidden to make alterations in the design of the water heater or
18. It is forbidden to make alterations in the design of the water heater or
modify it.
19. Any service operations must be performed by a specialized organisa-
19. Any service operations must be performed by a specialized organisa-
tion and qualified specialists. Improper installation may cause voiding of
guarantee maintenance.
20. The water heater is not intended for use by children and persons with
20. The water heater is not intended for use by children and persons with
reduced physical, sensory or mental capabilities, or a lack of experience
and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by an individual responsible for their safe-
ty. Children should be supervised to ensure that they do not play with the
appliance.
3. APPLICATION OF WATER HEATER
Electric water heater is used to heat cold water from water supply. Unit is
for household use.
4. PERFORMANCE PARAMETERS