Cisco Cisco Web Security Appliance S170 ユーザーガイド
4-3
Cisco IronPort AsyncOS 7.7.5 for Web User Guide
Chapter 4 Installation and Configuration
Before You Begin
Gathering Setup Information
Once you know how you will install the appliance in your network, you can gather the necessary
information, such as IP addresses, to enter in the System Setup Wizard. You can use the worksheet in
information, such as IP addresses, to enter in the System Setup Wizard. You can use the worksheet in
to write down the configuration options you decide on. Then, when you run the System Setup
Wizard, you can use the information you enter in the worksheet to configure the initial setup.
Table 4-1
System Setup Worksheet
Network Settings
Default System Hostname:
See
for more information.
DNS Servers:
Internet root DNS servers / organization DNS servers
Organization DNS Servers:
(maximum 3)
1.
2.
3.
Network Time Protocol Server:
Time Zone Region:
Time Zone Country:
Time Zone / GMT Offset:
Network Context
Is there another proxy on the network:
Yes / No
Other Proxy IP Address:
Other Proxy Port:
Interface Settings
Management Port
IP Address:
Network Mask:
Hostname:
Data Port
IP Address:
Network Mask:
Hostname:
Note: The Web Proxy can share the Management interface. If configured separately, the Data interface
IP address and the Management interface IP address cannot share the same subnet.
IP address and the Management interface IP address cannot share the same subnet.
L4 Traffic Monitor
L4 Traffic Monitor Wiring Type:
Simplex network tap / Duplex network tap
Routes
Management Traffic
Default Gateway: