Cisco Cisco Unified MeetingPlace Audio Server メンテナンスマニュアル
5-29
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8112)
OL-
Chapter 5 Repairing and Maintaining the 8112 Server
Replacing T1 Smart Blades or Smart Blades
Replacing T1 Smart Blades or Smart Blades
This section provides instructions on how to replace a T1 Smart Blade or a Smart Blade card and
transition module. The procedure for a T1 Smart Blade and a Smart Blade is the same.
transition module. The procedure for a T1 Smart Blade and a Smart Blade is the same.
Note
“T1 Smart Blade” and “Smart Blade” are two different components with different functions, even though
their names are similar.
their names are similar.
Note
Each T1 Smart Blade and Smart Blade card has a transition module in the same slot in the back of the
server. Whenever a T1 Smart Blade or Smart Blade card is replaced, its corresponding transition module
must also be replaced.
server. Whenever a T1 Smart Blade or Smart Blade card is replaced, its corresponding transition module
must also be replaced.
Warning
Handling these cards can result in static damage. Use an anti-static wrist strap, static-dissipating
work surface, and anti-static bags when handling and storing these cards.
work surface, and anti-static bags when handling and storing these cards.
Removing an old T1 Smart Blade or Smart Blade card
Step 1
Verify all steps in the section the
have been completed.
Step 2
Verify which T1 Smart Blade or Smart Blade card needs replacing and loosen that card’s two captive
screws on the top and bottom of the panel. See
screws on the top and bottom of the panel. See
Figure 5-20 Removing a T1 Smart Blade Card and Transition Module