Cisco Cisco Unified MeetingPlace Audio Server メンテナンスマニュアル

Scan the list of ports. Type

 l

 and press Enter to see the legend or press Enter to go to the next page. 

Continue until you have seen all the ports. If there is anything but dashes, explain to the site contact that 
some ports are currently in use and ask if it is alright to move forward with the repair.

Even though the site contact should have scheduled meetings to book all ports for the repair, users may 
be dialing in to schedule meetings or to listen to meeting recordings.

When all the ports have been shown, the “activity” command menu appears again. Type 

0

 and Enter to 

exit the “activity” command menu. The tech$ prompt appears.

Use MeetingTime to verify that the only meetings scheduled for the time required to perform the repair 
belong to the site contact.

The backup mechanism has changed in this version of the MeetingPlace Audio Server. It is now done 
through the MeetingPlace Backup Gateway. For information on how to install, configure, and use the 
backup mechanism, refer to the MeetingPlace Backup Gateway System Manager’s Guide.

Follow this procedure to power down MeetingPlace before turning the power switch to the off (“O”) 
position.

If not already connected, access the CLI by following the procedures in the 

 and 

Log in as technician. The tech$ prompt appears.

Type 

halt

. See line 1 in 

. Press Enter.

The second line in 

 appears. Type 

y

 and press Enter to confirm that you do want to power 

down the system.

meetingplace:tech$ halt

Are you sure (y/n)? y

NMI ioctl: Argument invalid/improper

Checking to see if the system is loaded...OK

System DOWN procedure has been initiated.

System HALT sequence has been initiated.

Please do not kill power until you see the "LynxOS is down" message.

meetingplace:tech$ The MeetingPlace software is DOWN

---> Halting the system

**** LynxOS is down ****