Cisco Cisco Unified MeetingPlace Audio Server メンテナンスマニュアル
4-27
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 4 Configuring the 8106 Server
Configuring the system
There are five sections that describe how to configure your 8106 server and give examples:
•
•
•
•
•
Configuring a T1 CAS system
This section explains how to configure T1 Smart Blades for a T1 CAS system.
Note
If this is a T1 CAS/IP mixed configuration, refer to the
. If this is a pure IP installation, refer to the
. If this is part of a T1 PRI installation, refer to the
. If this is part of an E1 installation, refer to the
Warning
The necessary cables should already be attached to the transition modules on the back of the server.
If they are not, refer to the
If they are not, refer to the
.
The “blade” command is used to configure all ports. Follow this procedure to configure the necessary
T1 Smart Blades. Refer to the examples following this section for more detailed information. For more
information about the “blade” command, see the
T1 Smart Blades. Refer to the examples following this section for more detailed information. For more
information about the “blade” command, see the
.
Step 1
If you do not already have terminal logging turned on, turn it on before proceeding. For information on
logging, see the
logging, see the
.
Step 2
At the tech$ prompt, type
blade -t <number of T1 ports>
and press Enter for a pure T1 CAS system
without any IP configuration
Step 3
Confirm the “blade” command you entered and type
y
and press Enter. If you entered the wrong
command, type
n
and press Enter and then re-enter the correct command.
The system tells you what it is configuring. The tech$ prompt appears when configuration is complete.
See
See
.
Table 4-4
Allowed Blade Configurations
Not Allowed
Allowed
T1 CAS and E1
T1 PRI and IP
T1 PRI and E1
E1 and IP
T1 PRI and T1 CAS
T1 CAS and IP