Cisco Cisco Unified MeetingPlace SMTP E-Mail Gateway クイック設定ガイド

This procedure is completed on the Domain Controller that includes the Cisco  Unified MeetingPlace 
Web Server as part of its domain.

Use export to save all of the registry settings to a flat file.

Open a command prompt.

Enter the following command: net stop W32Time

Point the domain controller to the external NTP source:

Run the following command: w32tm /config /manualpeerlist:<NTP provider> 
/syncfromflags:manual /reliable:yes /update

An example of an NTP provider is clock.cisco.com.

If the previous command completed successfully, enter the following command: net start W32Time

Verify that the external NTP source is active:

Run the following command: w32tm /stripchart /<NTP provider> /samples:2/dataonly 

The output should show the local time and the external NTP provider time. Compare the two times 
to confirm that there are not any differences between them. 

Proceed to the 

.

This procedure is completed on the Cisco Unified MeetingPlace Web Server that is part of the 
domain.

Complete the 

.

Use export to save all of the registry settings to a flat file.

Open a command prompt.

Enter the following command: net stop W32Time

Run the following command: w32tm /unregister

Run the following command: w32tm / register

Change the value of the registry setting 
“HKLM\SYSTEM\CurrentControlSet\Services\W32Time\Parameters\Type” to NT5DS

Initially, this will be set to NTP.