SINGER 3337 SIMPLE 取り扱いマニュアル

⚠

  Before cleaning the machine, disconnect the power supply by removing the plug from the 

electrical outlet. Turn the hand wheel to raise the needle to its highest position. Raise the presser foot 

lifter.  

To ensure the best possible operation of your machine, it is necessary to keep the essential parts 

clean. For daily machine use, it is recommended that you clean the machine weekly.
1.  Remove the bobbin cover and then the presser foot by pressing down on both sides of the 

presser foot. Removing the presser foot will provide better access to the needle plate and bobbin 

case area. 

2.  Turn the handwheel towards you until the needle is at the highest position. (The take-up lever 

should be visible over the top of the machine).

3.  Remove the 2 screws in the needle plate using the L-screwdriver provided with your machine. 

Remove the needle plate.

4.  Remove the bobbin from the bobbin case.
5.  Take a hold of the bobbin case with your thumb and index finger at about 7 o’clock. Push it lightly 

to the right as you lift, the bobbin case will easily slip out of the hook race area. 

6.  Using the small brush that was provided with your machine remove lint and fluff from the hook 

race area, as well as the feed teeth area.

7.  Your machine has been pre-lubricated at the factory; as a result oiling the bobbin case area is not 

necessary.

8.  To reinsert the bobbin case, make sure the needle is at the highest position. (The take-up lever 

should be visible over the top of the machine).

9.  Take a hold of the bobbin case with your thumb and index finger at 6 o’clock directly over the left 

screw at the center front of the bobbin case.

10.  Guide the forked end of the bobbin case under the feed teeth and then move the bobbin case 

from right to left, until it is seated correctly in the hook race.

11.  To ensure that the bobbin case is in the correct position, turn the handwheel towards you; the 

hook race should turn freely in a counter-clockwise direction.

12.  Make sure the needle is again at the highest position. Reposition the needle plate over the feed 

dogs and secure in place using the 2 screws that you removed earlier.

13.  Attach presser foot, insert bobbin and replace bobbin cover. You are now ready to sew.

This appliance is equipped with a durable LED illumination, which is expected to last for the lifetime of 

the equipment. 
Please contact a local service agent, should the lamp nevertheless require to be replaced.