Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch
Release Notes for 200, 300, 500, and ESW2 Series Switches Firmware Version 1.2.9
9
Release Notes
Problem:
When a PoE switch is connected to another PoE switch, one of the
switches overcomes the internal power supply of the other PoE switch, so the other
PoE switch cannot provide PoE power to powered devices. If the connection
between these switches is removed, the switch that received power from the other
switch will momentarily lose its power and reboot. (CQ135360, CQ138875).
PoE switch cannot provide PoE power to powered devices. If the connection
between these switches is removed, the switch that received power from the other
switch will momentarily lose its power and reboot. (CQ135360, CQ138875).
Solution:
Disable PoE on the ports connecting the two PoE switches.
Problem:
When clicking on the help link while using the web-based interface,
then browsing to a different page without closing the help page, clicking on help
again may display an error message. (CQ 142539)
again may display an error message. (CQ 142539)
Solution:
The user can either:
-
Check the error message "Do not show this error again" and click "Yes".
-or
-
Close the Help page prior to clicking the Help link again.
Problem:
On the 500X series of switches, the Port Speed display is shown as
"unknown" on the web-based interface when the uplink ports are enabled with 10
GIG speed. (CQ142146)
GIG speed. (CQ142146)
Solution:
Use the CLI to view the port speed on uplink ports.
Problem:
Given a stack configuration with the stack master as unit #2. On the Port
Vlan Membership page of the web-based interface, changing the value on the
Interface Type drop-down, the drop-down returns to unit #1. The information
displayed on the rest of the page belongs to the ports of the unit that was selected
using the drop-down. (CQ 141909)
Interface Type drop-down, the drop-down returns to unit #1. The information
displayed on the rest of the page belongs to the ports of the unit that was selected
using the drop-down. (CQ 141909)
Solution:
There is no workaround.
Problem:
When a device is in Layer 3 mode and receives an IP address from a
DHCP server, if the user changes this IP address to static, it will not be displayed on
the configuration file. The device will function correctly. (CQ 140928)
the configuration file. The device will function correctly. (CQ 140928)
Solution:
There is no workaround.
Japanese language files and firmware version compatibility guideline
Users will see a mismatch in the features between the English language and the
Japanese language when running certain combinations of firmware and language
files. Users will see new features added since version 1.1.1.6 in English instead of
Japanese in the GUI when running firmware version 1.1.2.0 and higher subject to
the following restriction:
Japanese language when running certain combinations of firmware and language
files. Users will see new features added since version 1.1.1.6 in English instead of
Japanese in the GUI when running firmware version 1.1.2.0 and higher subject to
the following restriction: