Cisco Cisco Unified IP Interactive Voice Response (IVR) 8.0(1) インストールガイド
Performing Post-Installation Tasks
62
Installing Cisco Unified Contact Center Express Release 8.0(1)
Performing Initial Setup for the First Node
After you install Unified CCX, use the web interface of Unified CCX
Administration to perform the initial system setup.
Administration to perform the initial system setup.
Unified CCX Administration is a web-based application that allows you to
control, configure, and monitor many functions of your Unified CCX system. The
setup procedure that you perform depends on:
control, configure, and monitor many functions of your Unified CCX system. The
setup procedure that you perform depends on:
•
Your deployment of Unified CCX with Unified CM
•
Your deployment of Unified CCX with Unified CME
•
Your deployment Unified CCX is SA (single-node) or HA (two-node).
Table 9
Post-Installation Tasks
Post-Installtion Task
Important Notes
Perform the initial setup of Unified CCX.
See the
The locale English_United_States installs automatically
on the server; however, you can add new locales to the
server, if required.
on the server; however, you can add new locales to the
server, if required.
See the Cisco Unified Communications
Operating System Administration Guide
available here:
Operating System Administration Guide
available here:
If applicable, configure any network management
systems in use at your site.
systems in use at your site.
See the Cisco Unified Serviceability
Administration Guide available here:
Administration Guide available here:
Back up your Unified CCX data daily.
See the Cisco Unified Contact Center
Express Disaster Recovery System
Administration Guide Release 8.0(1)
available here:
Express Disaster Recovery System
Administration Guide Release 8.0(1)
available here: