Cisco Cisco Agent Desktop 9.0 インストールガイド
Cisco CAD Installation Guide
60
August 4, 2014
6. By default, Base Services, VoIP Monitor Service, and Recording and Playback
Service are selected to be installed. Click Next to display the Ready to Install
the Program step (
the Program step (
).
Figure 13.
Ready to Install the Program step
7. Click Install to start the installation.
8. When the installation is completed, the CAD Configuration Setup utility starts
automatically. See
for
instructions on configuring your system.
CAD Configuration Setup Utility
The CAD Configuration Setup utility is launched automatically when the CAD base
services installation finishes. Use the CAD Configuration Setup utility to configure the
CAD base services. You can run the utility again later to change your configuration
settings.
services installation finishes. Use the CAD Configuration Setup utility to configure the
CAD base services. You can run the utility again later to change your configuration
settings.
The CAD Configuration Setup utility consists of a series of nodes that require you to
enter data. You must complete all of the nodes in the utility to configure and to run the
CAD base services successfully.
enter data. You must complete all of the nodes in the utility to configure and to run the
CAD base services successfully.
The nodes that appear when you run this utility depend on the following factors:
■
The host computer on which you launched the CAD Configuration Setup utility