Cisco Cisco MGX-FRSM-HS2 B Serial Frame Service Module インストールガイド

You are required to make initial SSL daughter card configurations through a direct connection to the 
CSM-S Certificate Management port (Cert. Mgt). After the initial configurations, you can make an SSH 
or Telnet connection to further configure the module. See Chapter 5 in the Catalyst 6500 Series Content 
Switching Module with SSL Installation and Configuration Note.

When the CSM-S powers up, it initializes various hardware components and communicates with the 
supervisor engine. The Status LED indicates the supervisor engine operations and the initialization 
results. During the normal initialization sequence, the status LED changes from off to red, orange, and 
green. The SSL daughter card Crypto LED is unused in this release.

For more information on the supervisor engine LEDs, refer to the Catalyst 6500 Series Switch Module 
Installation Guide.

 describes the Status LED operation.

Status

Off

The module is waiting for the supervisor engine to provide power.

The module is not online.

The module is not receiving power, which could be caused by the following:

Power is not available to the CSM-S.

Module temperature is over the limit

1

.

1.

Enter the show environment temperature mod command to display the temperature of each of the four sensors on the CSM-S.

Red

The module is released from reset by the supervisor engine and is booting.

If the boot code fails to run, the LED stays red after power up.

Orange

The module is initializing hardware or communicating with the supervisor engine.

A fault occurred during the initialization sequence.

The module has failed to download its Field Programmable Gate Arrays (FPGAs) on power up but 
continues with the remainder of the initialization sequence and provides the module online status from 
the supervisor engine.

The module has not received module online status from the supervisor engine. This problem could be 
caused by the supervisor engine detecting a failure in an external loopback test that it issued to the 
CSM-S.

Green

The module is operational; the supervisor engine has provided module online status.

Green 
to 
orange

The module is disabled through the supervisor engine CLI 

2

 using the set module disable mod 

command.

2.

CLI = command-line interface.

Crypto None.

Not used. Reserved for future releases.