Cisco Cisco ONS 15600 Multiservice Switching Platform (MSSP) インストールガイド

Read the Release Notes for Cisco ONS 15600 Release 7.2.

Log into the node that you will upgrade. For detailed instructions, refer to the Cisco ONS 15600 
Procedure Guide. 

Complete the 

.

Disable all other Ethernet devices (such as a dial-up adapter) on the workstation that runs CTC. For 
instructions, contact the Cisco Technical Assistance Center (TAC).

If you have multiple IP addresses on your workstation, you should remove them; you cannot run 
Software R7.2 if multiple IP addresses are configured. 

Verify that TSC cards are installed in Slots 5 and 10 and that the TSC in Slot 10 is active.

Complete the 

Ensure that your workstation is either one of the following:

IBM-compatible PC with a Pentium III/700 or faster processor, CD-ROM drive, a minimum of 384 
MB RAM and 190 MB of available hard drive space, running Windows 98, Windows NT 4.0 (with 
Service Pack 6a), Windows 2000 Professional (with Service Pack 3), or Windows XP Professional 
(with Service Pack 1)

UNIX workstation with Solaris Versions 8 or 9, on an UltraSPARC or faster processor, with a 
minimum of 384 MB RAM and a minimum of 190 MB of available hard drive space

This procedure steps you through the critical information checks and tasks 
you must complete before beginning an upgrade.

PC or UNIX workstation; Cisco ONS 15600 Software Release 7.2 (CD or 
soft copy)

Prerequisite Procedures None

Required

Onsite or remote

Superuser

This task verifies that all PC or UNIX workstation hardware and software 
requirements are met.

PC or UNIX workstation

Prerequisite Procedures None

Required

Onsite or remote (but in the presence of the workstation)

Superuser