Cisco Cisco Customer Voice Portal 8.0(1)

port 1:1

preference 0

dial-peer voice 4 pots

* \ Defines backup voice port (1:2) for the same trunkgroup

destination-pattern 888801….

port 1:2

preference 1

dial-peer voice 5 pots

* \ Routes calls to a third trunk group

destination-pattern 888802….

port 2:1

preference 0

dial-peer voice 6 pots

* \ Backup voice port for third trunk group

destination-pattern 888802….

port 2:2

preference 1

Unified CM Configuration for Call Routing (zone-prefix method)

Cisco Unified Communications Manager sometimes needs to be able to locate a Unified CVP
server to which to route a call (inbound call routing to Unified CVP). Also, Unified CVP needs
to be able to locate a Cisco Unified Communications Manager to which to route a transferred
call (outbound call routing from Unified CVP).

Do the following:

1. In Cisco Unified Communications Manager Admin, use Device > Gatekeeper to create

the gatekeeper device.

2. Use Device > Trunk to create an H.225 Gatekeeper Controlled trunk. (This is the trunk

to enable inbound call routing from Cisco Unified Communications Manager to Unified
CVP.)

–

Enable Media Termination Point required. (This is necessary for calls that originate
from Cisco Unified Communications Manager into Unified CVP because Unified
CVP cannot process the H.323 Empty Capability Set feature for inbound calls.)

–

Under Gatekeeper Information:

— Select the gatekeeper that was defined in the previous step.

— Select Gateway as the Terminal Type.

— Set technology prefix to 1#.

— Select a zone. (If left blank, Cisco Unified Communications Manager will register
to the first local zone defined in the gatekeeper.)

3. Create a Route Pattern that will point the desired set of DNIS values to Unified CVP:

Configuration and Administration Guide for Cisco Unified Customer Voice Portal Release 8.0(1)