Cisco Cisco IOS Software Release 12.4(22)XR
8
Release Notes for Cisco PDSN Release 5.5 in IOS Release 12.4(22)XR12
OL-23372-06
Migration to Cisco PDSN
Migration Steps
Migration to the Cisco PDSN Release 5.5 image is more than replacing Multi-processor WAN
Application Module (MWAM) cards with SAMI modules. Ensure that you plan your migration such that
migration activities have a minimal impact on an existing mobile subscriber’s service connections.
Application Module (MWAM) cards with SAMI modules. Ensure that you plan your migration such that
migration activities have a minimal impact on an existing mobile subscriber’s service connections.
lists the migration tasks that are based on the scenarios established in
Table 3
Migration Steps from Cisco PDSN 4.0 to 5.5
Scenario
Migration Steps
1
•
In SAMI cards with the Cisco PDSN Release 4.0 image, erase configuration on all
processors and reload Cisco PDSN.
processors and reload Cisco PDSN.
•
Configure the I/O memory (IOMEM) on all processors as 256 MB and save the
configuration to the NVRAM.
configuration to the NVRAM.
Note
If you have set the IOMEM size as 64 MB, ensure that you configure the memory
lite command. The recommended memory size is, however, 256 MB.
lite command. The recommended memory size is, however, 256 MB.
•
Upgrade to Cisco PDSN Release 5.5 and reconfigure the Cisco PDSN configuration on
processor 3.
processor 3.
•
Provision MS and PCFs to use the newly added Cisco PDSN Release 5.5-based PDSN
IP.
IP.
•
Provision the newly added PDSN with the HA to service MIP calls.
To minimize provisioning tasks, Cisco PDSN Release 5.5 reuses the IP address and routing
scheme used in one of the Cisco PDSN Release 4.0 processors.
scheme used in one of the Cisco PDSN Release 4.0 processors.
1. MS = Mobile Station.
2. PCF = Packet Control Function.