Cisco Cisco ASA for Nexus 1000V Series Switch

% There is no FPD image upgrade in progress.

Verify that the FPD upgrade was successful using the following command:

Router# show hw-module all fpd

To upgrade the ASA from the Supervisor 720 to the Supervisor 2T, perform the following steps:

Upgrade the ASA with the Supervisor 2T image while the Supervisor 720 image is still loaded on the 
Catalyst 65000 Series E Switch.

If you replace the supervisor card on the Catalyst 65000 Series E Switch before you upgrade the 
ASA, then the interfaces on the ASA will not be recognized, and you will not be able to load a 
new image.

Change the supervisor card from the Supervisor 720 to the Supervisor 2T on the Catalyst 65000 Series 
E Switch.

Upgrade the Catalyst 65000 Series E Switch with the Supervisor 2T image.

 contains open caveats in the latest maintenance release.

If you are a registered Cisco.com user, view more information about each caveat using the Bug Toolkit 
at the following website:

.

For information on the end-user license agreement, go to the following URL:

CSCtq41035

Incorrect interface MAC address after failover.