Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch インストールガイド

To rack-mount the switch in any standard rack, attach the rack–mount 
brackets to the sides of the switch with the supplied hardware and secure 
the brackets tightly.

For stability, load the rack from the bottom to the top, with the 
heaviest devices on the bottom. A top-heavy rack is likely to 
be unstable and may tip over.

To connect the advanced smart switch to the network:

Connect the Ethernet cable to the Ethernet port of a computer, 
printer, network storage, or other network device. 

Connect the other end of the network Ethernet cable to one of the 
numbered advanced smart switch Ethernet ports. 

The LED of the port lights if the device connected is active. Refer to 

 for 

details about the different ports and LEDs on each switch.

Repeat 

 for each device you want to connect to 

the advanced smart switch.

Cisco strongly recommends using Cat5 or better cable for Gigabit 

connectivity. When you connect your network devices, do not exceed 
the maximum cabling distance of 100 meters (328 feet). It can take up to 
one minute for attached devices or the LAN to be operational after it is 
connected. This is normal behavior.

If your switch is one of the PoE models, consider the following:

As a PSE (Power Sourcing Equipment) device, the switch can deliver a 
maximum of 15.4 Watts per PoE port to a PD (Powered Device).

The switch should be connected only to PoE networks without 
routing to the outside plant