Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch インストールガイド

PoE (if present)—(Amber) Located on the right of the port. Lights steady to 
indicate that power is being supplied to a device attached to the 
corresponding port.

100M LED (if present)—(Green) Located on the right of the port. Lights 
steady when another device is connected to the port, is powered on, and a 
100 Mbps link is established between the devices. When the LED is off, the 
connection speed is under 100 Mbps or nothing is cabled to the port.

Gigabit LED (if present)—(Green) Located on the right of the port. Lights 
steady when another device is connected to the port, is powered on, and a 
1000 Mbps link is established between the devices. When the LED is off, 
the connection speed is under 1000 Mbps or nothing is cabled to the port.

SFP (if present)—(Green) Located on the right of a GE port. Lights steady 
when a connection is made through the shared port. Flashes when the port 
is passing traffic.

The switch might also have a reset button. The switch can be reset by 
inserting a pin or paper clip into the reset opening. See 

 for details.

The power port is located on the back panel of the smart switch.

To use the Reset button to reboot or reset the smart switch, do the 
following:

• To reboot the smart switch, press the Reset button for less than 10 

seconds.

• To restore the smart switch configuration to the factory default settings:

1. Disconnect the smart switch from the network or disable all DHCP 

servers on your network.

2. With the power on, press and hold the Reset button for more than 

10 seconds.