Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch インストールガイド
200 Series 8-Port Smart Switches
3
Wall Mounting
N
OTE
The switch should be mounted so that the ports face up or down.
Do not mount the switch with the ports to the side, as this causes strain
on the connections.
on the connections.
There is a wall-mount kit packed with your switch. The dimensions for the
mount kit are as follows:
mount kit are as follows:
Mount the smart switch to the wall by drilling two pilot holes 95 mm (3.7
inches) apart, attaching the provided anchors and screws to the wall, then
sliding the switch into position on the screws.
inches) apart, attaching the provided anchors and screws to the wall, then
sliding the switch into position on the screws.
The switch must have a minimum of 5 inches (130 mm) of clearance on all
sides.
sides.
W
ARNING
Insecure mounting might damage the device or cause injury.
Cisco is not responsible for damages incurred by insecure wall-
mounting.
Cisco is not responsible for damages incurred by insecure wall-
mounting.
1 0.4 in/8 mm
2 0.9 in/22.2 mm 3 0.3 in/6.8 mm
4 0.7 in/17.6 mm
1
2
4
3
196243