Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch インストールガイド

Verify that a computer with Microsoft Internet Explorer (version 6 or higher) 
or Firefox (version 2.0 or higher) is available.

In order to access the switch with a web-based interface, you must know 
the Management IP address of the switch. The default configuration of the 
switch is to use its factory default IP address of 192.168.1.254 until it has 
obtained an IP address from a DHCP server, or it has been changed to a 
static IP address.

When the switch is using the factory default IP address, its System LED 
flashes continuously.   When the switch is using a DHCP assigned IP 
address or an administrator configured static IP address, the system LED 
lights steady. 

If the smart switch IP address is changed, either by a DHCP server 

or manually, your access to the smart switch will be lost and you must 
use the new IP address to configure the switch. 

To configure the smart switch:

Power on the computer and the switch.

Connect the computer to the switch. You can connect to the same 
IP subnet as the switch by connecting them directly with an 
Ethernet cable, or by connecting to the same LAN where the 
switch is located through other switches. You can also connect 
your computer to the switch from another IP subnet through one or 
more IP routers. 

Set up the IP configuration on your computer. 

a.

If the switch is using the default static IP address of 
192.168.1.254, you must choose an IP address in the range of 

192.168.1.2—192.168.1.253 that is not already being used by 
another device.

b. If the IP addresses will be assigned by DHCP, make sure your 

DHCP server is running and can be reached from the switch 
and the computer. You might need to disconnect and