Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch メンテナンスマニュアル
Administration
Diagnostics
Cisco Small Business SF200E Series Advanced Smart Switch
87
3
You can repeat the process to assign multiple Source Interfaces to the same
session. However, a source interface can be used in only one active session at a
time.
session. However, a source interface can be used in only one active session at a
time.
STEP 6
In the Port and VLAN Mirroring Session Table, select the session to activate and
click Edit.
click Edit.
STEP 7
For the Admin Mode, select Enable. (Deselecting the Admin Mode check box
retains the session configuration but disables it.)
retains the session configuration but disables it.)
STEP 8
For the Destination Interface, select Enable and select a Destination Interface port
to mirror the data.
to mirror the data.
!
CAUTION
When a port is configured as a destination probe port, the switch does not forward
or receive any traffic on that port and it does not respond to any pings received on
that port. All the previous configuration parameters on that port are cleared and the
port must be reconfigured when mirroring is removed from the port configuration.
or receive any traffic on that port and it does not respond to any pings received on
that port. All the previous configuration parameters on that port are cleared and the
port must be reconfigured when mirroring is removed from the port configuration.
STEP 9
If you want to mirror data only for a particular VLAN, select Enable for the VLAN
field and choose the VLAN ID from the list.
field and choose the VLAN ID from the list.
Only receive traffic for the specified VLAN is mirrored.
Select Reset Session to clear any configuration parameters applied during this
session.
session.
STEP 10
Click Apply and then click Close. The probe session begins.
NOTE
To end a probe session, select the session in the Port and VLAN Mirroring Session
Table and click Edit. Clear the Admin Mode checkbox, click Apply, and then click
Close.
Table and click Edit. Clear the Admin Mode checkbox, click Apply, and then click
Close.
To clear the current configuration for a session, select the session and click Edit.
Then select Enable for Reset Session field.
Then select Enable for Reset Session field.