Cisco Cisco Packet Data Gateway (PDG) トラブルシューティングガイド
IPv6 ACL Configuration Mode Commands
deny/permit (by host IP address) ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
Indicates all packets which match the filter are to be logged.
The IP address of the source host to filter against expressed in IPv6 colon notation.
Usage
Define a rule when a very specific remote host is to be blocked. In simplified networks where the access
controls need only block a few hosts, this command allows the rules to be very clear and concise.
controls need only block a few hosts, this command allows the rules to be very clear and concise.
Important:
The maximum number of rules that can be configured per ACL varies depending on how the ACL is
to be used. For more information, refer to the Engineering Rules appendix in the System Administration Guide.
Example
The following command defines two rules with the second logging filtered packets:
The following command defines two rules with the second logging filtered packets:
The following sets the insertion point to before the first rule defined above:
The following command sets the insertion point after the second rule defined above:
The following deletes the first rule defined above: