Cisco Cisco Aironet 350 Wireless Bridge 技術マニュアル
LEAP Authentication on a Local RADIUS Server
Document ID: 44100
Contents
Introduction
Prerequisites
Requirements
Components
Conventions
Overview of Local RADIUS Server Feature
Configure
CLI Configuration
GUI Configuration
Verify
Troubleshoot
Troubleshooting Procedure
Troubleshooting Commands
Related Information
Prerequisites
Requirements
Components
Conventions
Overview of Local RADIUS Server Feature
Configure
CLI Configuration
GUI Configuration
Verify
Troubleshoot
Troubleshooting Procedure
Troubleshooting Commands
Related Information
Introduction
This document provides a sample configuration for Lightweight Extensible Authentication Protocol (LEAP)
authentication on an IOS
authentication on an IOS
®
−based access point, which serves the wireless clients, as well as acts as a local
RADIUS server. This is applicable to an IOS access point that runs 12.2(11)JA or later.
Prerequisites
Requirements
Ensure that you meet these requirements before you attempt this configuration:
Familiarity with the IOS GUI or CLI
•
Familiarity with the concepts behind LEAP authentication
•
Components
The information in this document is based on these software and hardware versions.
Cisco Aironet 1240AG Series Access Point
•
Cisco IOS Software Release 12.3(8)JA2
•
Cisco Aironet 802.11 a/b/g/ Wireless Adapter that runs Aironet Desktop Utility 3.6.0.122
•
Assumption of only one VLAN in the network
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.