Cisco Cisco Aironet 1400 Wireless Bridge
5
Release Notes for Cisco Aironet Access Points and Bridges for Cisco IOS Release 12.4(10b)JDA and 12.4(10b)JDA2
OL-17693-02
System Requirements
Error Message %SYS-5-CONFIG_I: Configured from [chars] by [chars]
Explanation
The router configuration has been changed.
Recommended Action
This is a notification message only. No action is required.
Error Message %LINEPROTO-5-UPDOWN: Line protocol on Interface [chars], changed state
to [chars]
to [chars]
Explanation
The data link level line protocol has changed state on the interface shown.
Recommended Action
No action is required.
Error Message %SNMP-5-COLDSTART: SNMP agent on host [chars] is undergoing a cold
start
start
Explanation
The SNMP server completed a coldstart.
Recommended Action
Notification message only. No action is required.
Error Message %SYS-6-CLOCKUPDATE: System clock has been updated from [chars] to
[chars], configured from [chars] by [chars].
[chars], configured from [chars] by [chars].
Explanation
The system clock has been modified.
Recommended Action
This is an informational message only. No action is required.
Error Message %SYS-6-LOGGERSTART: Logger process started
Explanation
The logger process has been initialized and started.
Recommended Action
Recommended Action: No action is required.
Error Message DHCP-6-ADDRESS_ASSIGN
Explanation
The interface has been allocated an address by means of DHCP.
Recommended Action
None
Error Message NO_SSID_OR_NO_VLAN
Explanation
No SSID or VLAN is configured. (Example:%DOT11-1-NO_SSID_OR_NO_VLAN:
No SSID configured. Dot11Radio0 not started.)
Recommended Action
Use the CLI to assign an SSID, and VLAN if required, to the affected interface.
Use the IOS command logging facility is available that allows users to customize the severity level of
system error messages by determining the severity levels of system error messages that are reported or
discarded. The command is supported on 1100, 1130, 1200, 1240, 1250, and 1300 series access points
and 1400 series bridges. The events covered by this command are:
system error messages by determining the severity levels of system error messages that are reported or
discarded. The command is supported on 1100, 1130, 1200, 1240, 1250, and 1300 series access points
and 1400 series bridges. The events covered by this command are: