Cisco Cisco Aironet 1400 Wireless Bridge 릴리즈 노트

Error Message %SYS-5-CONFIG_I: Configured from [chars] by [chars] 

The router configuration has been changed.

This is a notification message only. No action is required.

Error Message %LINEPROTO-5-UPDOWN: Line protocol on Interface [chars], changed state 
to [chars] 

The data link level line protocol has changed state on the interface shown.

No action is required.

Error Message %SNMP-5-COLDSTART: SNMP agent on host [chars] is undergoing a cold 
start 

The SNMP server completed a coldstart.

Notification message only. No action is required.

Error Message %SYS-6-CLOCKUPDATE: System clock has been updated from [chars] to 
[chars], configured from [chars] by [chars]. 

The system clock has been modified.

This is an informational message only. No action is required.

Error Message %SYS-6-LOGGERSTART: Logger process started 

The logger process has been initialized and started.

Recommended Action: No action is required.

Error Message DHCP-6-ADDRESS_ASSIGN 

The interface has been allocated an address by means of DHCP.

None

Error Message NO_SSID_OR_NO_VLAN 

No SSID or VLAN is configured. (Example:%DOT11-1-NO_SSID_OR_NO_VLAN: 

No SSID configured. Dot11Radio0 not started.)

Use the CLI to assign an SSID, and VLAN if required, to the affected interface.

Use the IOS command logging facility is available that allows users to customize the severity level of 
system error messages by determining the severity levels of system error messages that are reported or 
discarded. The command is supported on 1100, 1130, 1200, 1240, 1250, and 1300 series access points 
and 1400 series bridges. The events covered by this command are: