Cisco Cisco WAP551 Wireless-N Single Radio Selectable Band Access Point インストールガイド
Cisco WAP551 and WAP561 Wireless-N Access Points
5
To mount the WAP device to a wall or ceiling:
S
TEP
1
Determine where you want to mount the device. Verify that the
surface is smooth, flat, dry, and sturdy.
surface is smooth, flat, dry, and sturdy.
S
TEP
2
Drill two pilot holes into the surface 2.75 inches (70 mm) apart for
your Cisco WAP device.
your Cisco WAP device.
S
TEP
3
Insert a screw into each hole, leaving a gap between the surface
and the base of the screw head.
and the base of the screw head.
S
TEP
4
Place the upper slots of the bracket over the screws, adjust the
screws accordingly, and slide the bracket down until the screws fit
snugly into the slots.
screws accordingly, and slide the bracket down until the screws fit
snugly into the slots.
S
TEP
5
Using the bracket as a template, drill two more holes for the lower
screws.
screws.
S
TEP
6
Insert a screw into each lower hole.
S
TEP
7
Slide the WAP device into the bracket, placing the cable through
the break-out tab found in the back of the bracket.
the break-out tab found in the back of the bracket.
Connecting the Cisco WAP551 and
WAP561 Wireless-N Access Points
WAP561 Wireless-N Access Points
The default configuration of the device has the Wi-Fi radio turned off. You
must perform the initial configuration using a wired Ethernet connection. To
connect the device to the wired network:
must perform the initial configuration using a wired Ethernet connection. To
connect the device to the wired network:
S
TEP
1
Connect the Ethernet cable to the Ethernet port of a switch, a router,
or a PC.
or a PC.
S
TEP
2
Connect the other end of the network Ethernet cable to the
Ethernet port of the wireless access point.
Ethernet port of the wireless access point.
After installation, all lights should be active. Refer to
for details about the different lights on each
switch.
4